Rainwater – Pressure Tank

A pressure tank,  which I think is the most important upgrade to a standard rainwater supply system,  looks like the photo on the right.

Small tanks are mounted on the pump, larger tanks like this one are on the ground.

Key Features

What you get is a cylindrical storage tank storage tank with an internal membrane.

The top part of the tank, above the membrane, is filled with compressed air.

The bottom part of the tank will be filled with water by the pump from a connection at the tank base.

In the top half of the tank there is an air valve where you can check the air pressure and add more air if necessary.

How It Works

 The top of the tank is pre-charged with air to a pressure slightly lower  than the ON setting of the pressure switch.

When the pump starts water is pumped into the tank compressing the air until the maximum pressure is reached.

If you turn on a tap  the compressed air will push water out of the tank until the  tank is almost empty (when the pressure will have dropped to the minimum level)

If you use less water than that stored in the tank the pressure doesn’t drop enough so the pump doesn’t start.

Once the pressure switch turns the pump back on, the pump fills the tank while at the same time supplying water to your system. Even if you turn the tap of the pump will continue to run until the tank reaches maximum pressure.

Tank Sizing

Although very small tanks are available about the smallest tank I would recommend would be an 18litre tank, which would give a flow volume of around 5litres between pump starts.

A 35litre tank with a flow volume of around 11litres between pump starts would ensure a toilet flush would not exhaust the tank.

Why Should You Get A Pressure Tank?

It can cost more than some pumps to buy the pressure tanks so why buy it is an important question.
To find out the problems with a standard set up see the post “Rainwater – Pump Issues
The pressure tank should:

    • Double, or even treble the life of the pump, by reducing the number of pump starts and pump run time.
    • Significantly reduce the power usage by ensuring the pump mainly runs at the design rate.
    • Reduces the noise nuisance by less frequent pump runs.

 

For more posts about tank water see the Rainwater Section under the Sustainability Tab

 

2 thoughts on “Rainwater – Pressure Tank”

  1. I size the tank according to the gpm capability of the pump.” For example; a 8 gpm pump should have no less than a tank that will hold at least 8 gallons. Also this will insure that the pump’s running time will be at least 1 minute. The confusion in buying a bladder type tank is the tank size may be listed as an 20 gallon but it will actually ony hold 5 or 6 gallons. Some tanks at Home Depot are 60 gallons but they only will hold 12 gallons. In most cases the tank’s size is listed in overall area but the true fact is that the actual “draw” of water is only a quarter of that area. A tank sized at 30 gallons will give off approx 8 gallons. These sizes marked on the tanks can be very confusing to the average customer.

    1. A way of getting the maximum draw off from a pressure tank is run the system at a low pressure. This will mean the draw off volume is closer to 1/3 the tank volume rather than 1/4.
      Brian

Comments are closed.

Exit mobile version